Vehicle Based Satellite Antenna

Vehicle based satellite antenna

The very new satellite antenna, approved by Satellite Radio has been specially designed to receive signals from three satellites and other network of ground-based repeater transmitter. Satellite antennas are exceptionally sensitive and delicately specified to assist reception of satellite signals under a variety of conditions across the country. It is important to read the Instructions carefully to ensure that the antenna is mounted properly in the best location in order to provide optimum reception quality and feel satisfied.


Mounting location:

The satellite antenna must be mounted horizontally on a metal surface measuring at least18 inches by 18 inches. The best reception quality is achieved at the highest point of the vehicle like the roof but the trunk lid is an alternative location for convertibles and for some sedans. It is important that the antenna has a clear view to the satellites and ground-based repeaters and should therefore be mounted in an unobstructed location like clear of roof racks, sunroofs and other antennas.


Installation antenna:

Installation should be carried out when conditions are at room temperature or above. Initially, colder temperatures could affect the remedial time of the antenna module’s adhesive. Secondly, when increasing the antenna module on a sedan, it will be easier to work with the rubber molding around the window. The antenna unit may be removed, using a nylon cord like fishing line to cut through the adhesive pad between the antenna unit and the vehicle. Work from the front to the tail in a side-to-side cutting motion. Any remaining adhesive may be removed with an appropriate cleaner.


The antenna cables should be tucked and retreat underneath the rubber molding around the rear window and into the trunk. Clean the general area where the antenna is to be mounted. Identify and mark the precise location of the transmitter module. Peel off the protective liner from adhesive pads. Starting with the tail in position, work to-wards the module while applying force of approximately 12 psi for a minimum of 15 seconds. The window molding will be more flexible and easier to work with at room temperature. Ensure the molding is clean and if necessary apply a small amount of oil to make the process easier. If there is no suitable cable channel, the cable may be routed directly from the window molding to the right or left corner of the trunk.




 

 
Translate Page Into German Translate Page Into French Translate Page Into Italian Translate Page Into Portuguese Translate Page Into Spanish Translate Page Into Japanese Translate Page Into Korean

More Articles on Antenna

 

 

Search This Site

 

Related Products And FREE Videos on Antenna





 

More Articles on Antenna


Indoor Antennas For Household Purposes

... frequencies into electromagnetic waves and vice versa. Indoor antennas are the antennas used inside the home or any other such place. There are varieties of indoor antennas. All the electronic devices have inbuilt antennas but there is a need to fix another antenna outside for better reception of signals. ... 

Read Full Article  


Choosing Right Direction For Antenna

... tilted parallel to the direction of the transmission then it receives good signals. It is better to place two antennas one being in horizontal direction and the other being in the vertical direction. This helps for the antennas to receive both horizontal and vertical signals. The antenna direction control ... 

Read Full Article  


Loop Antennas

... antennas. A loop can be wound in two ways that are box or spiral. In case of winding up the loop antenna in a box, it is wound perpendicular in the same direction of the loop. In the spiral form the antenna is wound up parallel to the loop s diameter. This will make the each and every loop smaller. A ... 

Read Full Article  


Dipole Antenna

... antennas, radio antennas, satellite antennas, omni directional antennas, and cell phone antennas are some of the types of antennas. Short wave permanent antennas can be trimmed to the proper length. Every dipole antenna should have an insulator at the ends. Without insulator if the dipole is used with ... 

Read Full Article  


Installing A Television Antenna

... of the service. The direction of the antenna in and its height should be carefully adjusted to obtain the best picture. Small changes can make a big difference. If the picture is spoiled by snow or by ghosting or by both of these undesirable effects, the following pointers may help. 1. Snow or harsh grain ... 

Read Full Article