Satellite Antenna

Satellite antenna 

The satellite antenna is an artificial satellite, which is placed in space. The main purpose of satellite antenna is to serve communication. It solves the purpose of reconnaissance with the use of radio at microwave frequencies. An earth station is located on the ground, which use to transmit the radio waves. The satellite antenna use geosynchronous orbit beside recent system with the earth orbiting satellite.


Tips for satellite antenna

Mostly satellite antenna is build of materials of junk that most of the people want it to throw away. It is very easy to make a satellite antenna. Build a VHF or UHF ground plane antenna and larger wire scrap. The vertical element should be soldered to the conductor located in the center. Attach all the four corners with the nuts and bolts. Vertical element should be built a bit longer then calculated. Radials should be bend down almost twenty five to thirty degrees.

Connector flange is not too far away as the distance is very small. The vertical element should be trimmed in comparatively smaller increments to obtain minimum SWR towards the lower end, where the will be done. The SWR should be lowest near the center when it starts to go back. If it is not possible then trim the SWR wire till it is finished. Bend the radials one by one to obtain one to one SWR.


Another important source of antenna material, which can be recycled, is the corroded junked ham beams. First step is to disassemble the aluminum element from present in the boom. Give an acid bath to the elements that are being disassembled. Drill the holes on one boom away from the existing holes. The distance should be around 2.5 cms. Secure all the elements with the new metal screws in a way that the size is larger then the original size.

This is done to serve the purpose that new screws fitted well in the old holes. While constructing the antenna try not to lower the expenses by not using bad quality products. Always use the products made up of stainless steel. The extra cost will be compensated in the coming years when there will be low maintenance cost.




 

 
Translate Page Into German Translate Page Into French Translate Page Into Italian Translate Page Into Portuguese Translate Page Into Spanish Translate Page Into Japanese Translate Page Into Korean

More Articles on Antenna

 

 

Search This Site

 

Related Products And FREE Videos on Antenna





 

More Articles on Antenna


Outdoor Antennas For Household Purposes

... signals so it is required to place the antenna in such a place where there are no obstacles. There should be free flow of signals from the satellite. They provide good signals that are free from disturbances. For a household purpose an antenna is required for getting a good TV, and radio signals. A booster ... 

Read Full Article  


Small Directional Antenna

... signal. Small directional antennas: Small directional antennas are one of the types of directional antennas. These are the most popular rooftop antennas because of their modest size and ghost reducing characteristics. These antennas are also called as multi element rooftop antennas. These antennas act ... 

Read Full Article  


Cell Phone Jammers

... user can notice that the phone is out of range. The jammer has the ability to block the mobile phone over the radius of five miles. The effectiveness of the jammer depends on the factors like temperature, humidity, building presence and setting of outdoor. History of cell phone jammers In past recent ... 

Read Full Article  


Antenna Parameters

... a feature known as polarization filter, which removes unwanted polarization and transmit waves that have the desired polarization. 4) Efficiency: The efficiency of the antenna describes the actual performance and use of the antenna. It is measured by examining the ratio of the power emitted to the amount ... 

Read Full Article  


Radio Antenna

... no magnitude and no mass. This antenna cannot actually exist but is useful as a theoretical model for comparison with all other antennas. 2. The dipole antenna is basically two wires pointed in opposite directions given either horizontally or vertically with one end of each wire connected to the radio ... 

Read Full Article