Antenna Repairs

Antenna repairs

An antenna is also known as the aerial. Antenna transmits and receives the radio active waves in the class of electromagnetic waves. An antenna is the arrangement of the electric conductors. Basically it serves the purpose of converting the electrical of radio frequency into electromagnetic waves and vice versa. An antenna is used for many purposes like television broadcasting, radio communication, space exploration and many more. Usually antennas are placed in the air or the outer space. Use of antenna will enable the television to forecast all the channels and radio will catch the radio waves, and the user can listen to different programmers.


Causes of antenna repairs

The antennas get deteriorated very soon; this issue has become a topic of discussion. The main cause of deterioration is bad standards in respect of design and construction of towers and supporting structures. Another cause is that less attention is given to design of antenna and tower component. Many factors are responsible for the durability of the antenna.



Antenna repairs

Antenna should be repaired very carefully; firstly, the motor of the antenna should be removed and disassembled. This is done to remove all the broken pieces of the cable in the house of motor. After the cable wires are removed then reinstall the housing unit of motor and do not install lock nuts and exterior trim pieces. It is always advisable that antenna should be repaired with the help of two people one will turn ignition and other will listen to the motor of antenna. This will enable to know about the fact whether the motor is spinning. One fact that is needed to be taken care of is that wire should be taken all the way down. As soon as the cable made up of nylon is correctly placed then the first person will switch off the radio and then the motor of antenna will automatically pull the cable of the antenna in the house of motor. Second person will place the cable in the opening house. In the end replace the three main things like trim pieces, voila and lock nut.




 

 
Translate Page Into German Translate Page Into French Translate Page Into Italian Translate Page Into Portuguese Translate Page Into Spanish Translate Page Into Japanese Translate Page Into Korean

More Articles on Antenna

 

 

Search This Site

 

Related Products And FREE Videos on Antenna





 

More Articles on Antenna


Cell Phone Jammers

... effects also have much negative effect in the life of the people. To overcome the negative aspects of the cell phone, the cell phone jamming device is the best alternative to other expensive products of cell phone jamming. Mainly the cell phone jammers were developed for enforcing the law and serving ... 

Read Full Article  


Home Antenna Systems

... They receive signals directly from the satellite and the reception depends on the clearance of the sky. A booster can be attached to the antenna for better reception of signals. This avoids the reception of environmental disturbances. 4. Wireless antennas: These antennas are used for public safety and ... 

Read Full Article  


Loop Antennas

... antenna will receive the signals on the opposite side and off side of the antenna signal will be very weak or there is possibility of no signals. When there will be no frequency the user will pick up another on the same frequency. A loop antenna may have an amplifier. Loop antennas are available in many ... 

Read Full Article  


Uses Of Antenna

... There are antennas depending on the frequencies of signals. Some of the examples are Long wave or low frequency antennas, short wave and high wave frequency antennas. Uses of antenna: Antennas have a wide range of usage. Antennas act as a line of sight between the transmitting and reception aerial for ... 

Read Full Article  


Vehicle Based Satellite Antenna

... from the front to the tail in a side-to-side cutting motion. Any remaining adhesive may be removed with an appropriate cleaner. The antenna cables should be tucked and retreat underneath the rubber molding around the rear window and into the trunk. Clean the general area where the antenna is to be mounted. ... 

Read Full Article